Warnings – AEG TURBO 1480 User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Warnings
Before “ Follow the instructions for installation and electrical connection.
installing... _
connect the appliance it it is damaged (for example dur
ing transport).
- Any water found in the detergent dispenser drawer is there as a
result of factory testing.
- To remove any manufacturing residues from the drum and
detergent dispenser drawer, carry out a wash cycle without any
laundry, with the machine set on the 60°C coloureds pro
gramme and with 1/2 a measure of detergent.
Warnings AEG household electrical appliances comply with general techni-
(washing) cal safety manufacturing standards and with all safety regulations
on the use of electrical appliances. However, the manufacturer is
obliged to bring the following safety points to the attention of the
user:
- Before using the appliance, make sure that the voltage and type
of current indicated on its rating plate correspond to the mains
voltage and type of current in the place where it is to be
installed. The rating plate also gives details of the electrical pro
tection required.
- If the appliance is installed in a location which is not insulated
against frost, the emergency emptying procedure (see “Emer
gency emptying”) should be used whenever there is any risk of
the temperature dropping below zero.
- Always disconnect the appliance before cleaning it or carrying
out any maintenance. To be absolutely safe, check that the plug
is removed from the socket or that the mains switch or safety
circuit breaker are in the OFF position (see instructions for
installation and electrical connection).
- Avoid spraying the appliance with water.
- Never remove the plug from the socket by pulling the cable;
always take hold of the plug itself!
- Never start the appliance if:
■ the power supply cable is damaged
■ there are obvious signs of damage in the control panel area,
to the top or along the base.
- Repairs must only be carried out by qualified persons.
Inexperienced repairs can seriously endanger the user.
Always contact the Service Centre or an authorized dealer. Only
genuine AEG spares comply with all standards!