AEG TURBO 1480 - Manual (Page 40)

... the machine does not empty or does not spin:
■ Check whether the drain hose is kinked.
■ Check whether the filter is blocked.
... spinning is uneven:
■ If an excessive amount of foam has been formed, the machine
starts spinning and then stops until the foam has gone. Spin­
ning then resumes normally.
When selecting the next programme, check the amount of
detergent used.
... the machine makes strange noises:
■ The machine is fitted with a modern starting system which
makes an unusual whistling or hissing noise, compared with
other machines.
This new system allows spinning to be started more gently
and provides better control of gradual increase in spin speed.
This improves machine performance and reduces water con­
sumption.
... too much foam forms during washing:
■ Too much detergent is being used or the detergent is of the
wrong type. Check the amounts required.
... water is ieaking from the bottom of the machine:
■ Check whether the inlet hose is leaking.
■ Check whether the drain hose clip has worked loose.
■ Check whether thè drain hose is damaged.
■ Check that the filter is fully screwed in and properly fitted.
... washing resuits are poor:
■ Too little detergent has been used or detergent is of the wrong
type.
If insufficient detergent is used, the laundry will look grey and
lime deposits will be left in the machine. Use the correct
amount of detergent.
■ Check whether stains were adequately treated prior to wash­
ing.
■ Check whether the programme and temperature selected
were correct.
... stains remain even though they have been treated before
washing:
■ Probably the stains are indelible. Check with an expert.
... there are grey marks on the laundry:
■ Laundry stained with grease, creams or oil has been washed
with insufficient detergent. The detergent was not strong
enough to shift these stains.
■ Check whether the temperature selected was too low.
40