AEG OKO FAVORIT 3130 - Manual (Page 19)

Setting the rinse aid quantity to be dosed
The dispensing unit is located inside the filling opening of the rinse aid dispenser.
You can use it to set the rinse aid quantity on a scale of 1 -6 corresponding to a
1-6 cm^ rinse aid addition. The rinse aid dosage js factory-set to "3". At this
setting, there is sufficient rinse aid in the full dispenser for around 50 washing pro­
grammes.
You Should adjust the amount dispensed if you discover imperfect crockery re­
sults (see the section on “If you think your dishwasher is not working properly'’).
□ To set the dose, open the dispenser by twisting the cap V4 revolution
anticlockwise (Fig. 7).
□ Set the dose selector to the required position with a screwdriver.
Fig. 9 KLD1 (1)
Si
o
□ Then close the cap again by twisting it. clockwise.
□ Wipe off any spilt rinse aid with a cloth.
Filling with detergent
Importanti Never use conventional washing-up liquids. The latter cause heavy
frothing, may even imply a loss of machine function, and the dishes will not be
cleaned. Use only branded dishwasher detergent for domestic dishwashers.
Always store the detergent in a dry place in a sealed container. Lumpy detergent
will not clean dishes.
Before starting a washing programme (except ''Pre-wash"), you must fill the
detergent dispenser with dishwasher detergent powder. The detergent is auto­
matically dispensed during the programme.
59