AEG OKO FAVORIT 3130 - Manual (Page 36)

Connection
Water supply
Your dishwasher has been built in accordance with the vaitd regulations govern-
ing water-consuming appiiances and is equipped with safety devices which
prevent used water from flowing back into the drinking water mains. Your dish­
washer can be connected to either a cbid or hot water suppiy of max. 60 °C.
Never connect your dishwasher to open hot water appiiances and continuous
flow heatersi
The suppiy hose is fitted, with'a screwed hose connection (to DiN 259) and can
be connected to an outlet vaive (water tap) with maie thread
Suitable washers are suppiied with the machine. Do not use any washers other
than these!
The nut of the screwed hose connection can be tightened by hand. If you require
a supply hose which is ionger than the one supplied, use only the VDE-approved
complete hose kit (obtainable from our serwce centre) continuously and to
adequate length.
Never lengthen existing hoses.
Important note! The supply hose must not be kinked, squashed, or twisted.
Please ensure careful running.
To avoid reductions in water supply to the kitchen, we recommend you to install
a separate tap. Failing this, fit a branch piece to the existing water tap.
Additional installation expenditure (on the building side) can be reduced by use
of conventional sink mixers with a connection and shutoff valve.
Minimum water pressure:
1 bar(10N/cm"; 100 kPa).
if your water pressure is under 1 bar, please ask our sen/ice centre for advice.
Maximum allowable virater pressure:
10 bar (100 N/cm^ 1 MPa).
For a water pressure over 10 bar, a pressure-reducing valve (obtainable from your
specialist retailer) must befitted upstream.
St
C5
76