Setting the dishwashing programme – AEG OKO FAVORIT 3130 User Manual
Page 25
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting the dishwashing programme
n Close the door.
n Fully turn on the water tap, if it Is off.
Importanti If a washing programme has been started despite the water tap being
turned off, switch off your machine, turn on the water tap, and reset the washing
programme.
Setting the dishwashing programme
□ Turn the programme switch clockwise to position A, B or C as shown in the
programme chart.
n Turn the programme selector to the programme you require (see "Programme
chart"). The programme starts.
During the programme cycle, the programme cycle indicator cycles fonward,
indicating the status of the machine washing programme in each step. During
heating in the washing and rinse aid cycles, the programme switch remains
stationary until the necessary temperature is attained.
Programme correction
□ You can correct any washing programme you have inadvertently set wrongly
by switching off your machine with the programme selector (O position).
n
Reset the washing programme you require.
Interrupting the programme
□ A running washing programme is interrupted if you open the door.
□ Reclose the door. TTie washing programme restarts from the position where it
was interrupted.
□ You should open the door during the progfarnme cycle only when absolutely
necessary. When you reclose the appliance, the penetrating air is strongly
heated and expands. This may lead to programme cycle irregularities requiring
service centre attention.
65