Corners, Step 6 – Arrow Storage Products KM1010 User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Step 6
Parts Needed For
Corners
18995 Wall Panel (2)
*9372 Front Wall Panel (2)
»9156 Corner Panel (4)
NOTE
The remainder of the building assembly
requires many hours and more than one
person. Do not continue beyond this point
if you do not have enough time to com
plete the assembly today. A partially
assembled building can be severely
damaged by light winds.
Each screw and bolt in the wall re
quires a washer.
1
Position a
corner panel
at the
corner of the floor frame as shown.
The widest part of each corner panel
must be placed along the side of the
building for all four comers. Fasten
the corner panel to the floor frame
with four screws.
Support the corner panel with a step
ladder until a wall panel is attached.
2
Attach the
front wall panels
to the
frontcorner panels, as shown. A small
gap will exist between front wall panel
and ramp.
3
Attach the
wall panels
to the rear
corner panels, as shown.
NOTE
Be careful to install the correct
panel in each position as shown
4
Double-check the part numbers of
the wall panels, before proceeding.
The floor frame must
be
square
and level or
holes will not align.
8995
8995
Crimped Rib
Underneath
Panels rest on
frame as shown
«i' . •
#8Ax5/16"Scr8W
19