Arrow Storage Products KM1010 - Manual (Page 20)

step?
Parts Needed For
Frames
• Door Track Assembly (1)
• Rear Wall Angle Assembly (1)
• Side Wall Angle Assemblies (2)
• Rear Wall Channel Assembly (1)
• Side Wall Channel Assemblies (2)
The main frame pieces give rigidity to
the side walls and provide a surface
for attaching the gables which sup­
port the roof.
1
Fasten the rear wail angle as­
sembly across the inside top of the
rear wall using screws.
2
Fasten the rear wall channel as­
sembly across the middle of the rear
wall using screws.
3 Fasten the sidewall angles across
the inside top of the side panels us­
ing screws. Side wall angles must
overlap rear wall angle in corners.
4 Fasten the side wall channel
assemblies across the middle of the
side panels using screws. Fasten
overlaps in rear corners with screws.
5 Fasten the door track assembly
(holes on top) across the top of the
front wall panels using screws. See
the figure.
NOTE
The wall channels behind the
front wall panels will be installed
in a later step.
Wall Angles
Must Face
Inside
Building
STEP STEP
3 4
Long Leg
on Top
Opening
Facing in
Short Leg
on Bottom
20