ADLINK PXIe-3975 - Manual (Page 32)

20 Getting Started
2.3.13 Replacing the Hard Drive
The PXIe-3975 provides a SATA 2.0 port with a pre-installed 2.5"
SATA hard drive. Alternatively, a 2.5" solid state disk (SSD) can be
used for shock/vibration resistance. This section explains proce-
dures for replacing the HDD.
1. Locate the four screws attaching the hard drive to the
bracket on the rear of the PXIe-3975 controller.
2. Remove the screws, as shown.
3. Gently lift and remove the SATA hard drive, as shown,
being careful to not bend or break the SATA Board-to-
Board connector.