ADLINK cPCI-6870 - Manual (Page 56)

42 Board Interfaces
4.4 Switch and Jumper Settings
Mode Switch (SW2)
Switch SW2 is a multi purpose switch that allows users to
define the board operating mode. Four pins independently con-
trol the mode setting. All are set to OFF by default.
Table 4-25: Mode Switch Settings
Pin# Status Description
1
OFF
Universal Mode: The cPCI-6870 in a peripheral slot has
CompactPCI bus communication with the host board in the system
slot. The cPCI-6870 can boot-up in a peripheral slot and be
recognized by the host board in the system slot as a PCI device.
ON
Satellite Mode: The cPCI-6870 in a peripheral slot has no
CompactPCI bus communication with the host board in the system
slot. The cPCI-6870 behaves a as standalone blade in the
peripheral slot.
2
OFF
When the system does not include a CMM (Chassis
Management Module), set this pin to OFF to allow IPMI to run in
"without CMM mode".
ON
When the system includes a CMM, set this pin to ON to allow
IPMI to run in "with CMM mode".
3
OFF
The cPCI-6870 cannot boot-up when installed in a peripheral slot if
there is no host board in the system slot.
ON
The cPCI-6870 is able to boot-up when installed in a peripheral
slot if there is no host board in the system slot. The cPCI-6870
behaves as a system board in all slots. (Set this pin to "ON" if the
cPCI-6870 is installed in a blade server backplane).
4
OFF
The cPCI-6870 power on/off state is controlled by the ejector
handle state.
ON Force the ejector handle state to "closed".