ADLINK Express-LPC - Manual (Page 55)

Page 55 Express-IA533 User’s Manual Page 55 Express-IA533 User’s Manual Express-LPC User’s Manual Page 55
Remote Access
Select this option to Enable or Disable the BIOS remote access feature here.
Enabled Remote Access requires a dedicated serial port connection. Once both serial
ports are configured to disabled, you should set this value to Disabled or it may cause
abnormal boot.
Serial Port Number
Select the serial port you want to use for the remote access interface. You can set the value
for this option to either COM1 or COM2.
If you have changed the resource assignment of the serial ports in Advanced>Onboard
Device Configuration>SuperIO Configuration, you must Save Changes and Exit, reboot the
system, and enter the setup menu again in order to see those changes reflected in the
available Remote Access options.
8.3.10 Remote Access Configuration
Remote Access Configuration
Remote access configuration provides the settings to allow remote access by another
computer to get POST messages and send commands through serial port access. This
screen will not be visible if the module is used on a carrier w/o a SuperIO chip, due to lack of
serial port support.