Ambir ImageScan Pro 820i - Manual (Page 21)

21
Attention
 DO NOT load more than 50 sheets of paper
(18 lb./70 g/m2,) into the ADF.
 Paper fed into the ADF must be a minimum
of 2‖ x 2‖ (5.08 x 5.08 cm, W x L).
 Make sure there are no gaps between the
document stack and the paper-width slider;
otherwise, the scanned images may be
skewed.
 Although the documents should be loaded
firmly in place to ensure optimum scanning
accuracy, they should never be wedged in
so tightly that the process of feeding them
through the scanner is strained.
 DO NOT load additional paper into the ADF
while the unit is feeding and scanning.
Loading Business Cards
1. Load the business cards, headfirst and face
down, toward the center of the ADF and all the
way into the ADF until touching the bottom.
For single-sided scans, load the business cards
face down.
For double-sided scans, load the business cards
in the desired order.
2. Adjust the paper width slider to the business card width. The paper width
slider should be gently touching both sides of the business cards.
Loading Plastic Cards
Attention
 Make sure the plastic cards you wish to
scan are loaded horizontally into the ADF.
 Max. thickness of each plastic card is 0.76
mm (ISO 7810 STANDARD), embossed card
is 1.2 mm.
1. Plastic cards can be embossed credit cards, driver licenses, ID cards,
insurance cards, Medicare cards or any membership card. Make sure to
load the embossed side of the embossed card face down into the scanner.
Load the plastic card horizontally, headfirst and face down, toward the
center of the ADF.
For single-sided scans, load the card face down.