Cino L780BT HC - Manual (Page 3)

Preparations before Using
Install the Battery
2
Ensure the battery contacts of the battery pack
are facing the charging contacts inside
the battery cavity.
Slide the battery pack into the battery cavity until
hearing a click sound before locking it with the
end cap. The scanner will give 4 beeps when the
battery pack is installed properly if the battery
ack still has power. p
Secure the end cap with the screw provided.
Charge the Battery
Choose an appropriate plug and slot it into the
power adapter cavity until it is locked. Then plug
the AC power plug into the AC wall socket.
Plug the DC power cord of power supply unit
into the DC Jack of cradle. The smart cradle will
issue the power on beeps and the center
indicator will give one blue blink. If you use the
charging cradle, please check the power
indicator of charging cradle turns steady blue.
Place the scanner on the cradle. The status
indicator of scanner will turn steady red if the
battery is not fully charged. When the battery is
fully charged, the status indicator of scanner will
ash green at regular interval. fl
For first use, please charge the new battery pack
or 8 hours prior to use. f
Use USB Bus Power
If USB 3.0 is available in your host device, both
battery charging and regular operation can be
supported by the USB Bus Power without using
external power supply.
If only USB 2.0 is available in your host device,
you are recommended to use power supply as
power source. Because the supplied power of
USB2.0 is not enough to support both battery
harging and regular operation simultaneously. c
If you want to use this feature, please slide the
USB bus power switch to “ON”. Then connect
the cradle and host device via USB cable.