Cino L780BT HC - Manual (Page 5)

Use FuzzyScan in PAIR Mode
Ensure the battery is fully charged. You may refer to the section of
Preparations before Using for details.
Please choose your desired interface cable, then plug it into the host
interface port of the smart cradle and connect it to the host device.
USB PS/2 RS232
Turn on the power of your host device.
Please note that the scanner has been pre-paired already, if the scanner
is shipped together with the smart cradle. You will see the link indicator of
scanner gives 1 blue blink per 2.5 seconds and the middle indicator of
smart cradle turns steady blue. If the scanner and smart cradle just give
alternating red and green blinks (“Uninstall” state), please follow steps
5-6 to establish the connection between the scanner and the smart
cradle.
Scan “PAIR mode” command. The status indicator of scanner will turn
steady red.
Uninstall
PAIR Mode
Place the scanner on the smart cradle, then you will hear one short beep
to indicate the pairing process is activated. The scanner will give
continuous short clicks and the link indicator of scanner will flash blue
quickly during the pairing process. When you hear 4 beeps in ascending
tone, the pairing process is completed. You will see the link indicator of
scanner giving 1 blue blink per 2.5 seconds and the center indicator of
the smart cradle turning steady blue.
If the scanner pairing process failed or it’s not placed on the smart cradle
within 20 seconds, you will hear 2 “Di-do Di-do” beeps to indicate pair
failure, the scanner will return to uninstall state automatically.
Scan the corresponding host interface quick set command to complete
the installation.
The default host interface of smart cradle is preset to USB HID. If you
want to set the host interface to USB COM, you have to install the USB
virtual COM software driver into your host device before using the
scanner. Please visit the CINO website to download the software driver.
4