Cino L780BT HC - Manual (Page 7)

Use FuzzyScan in HID Mode
Ensure the battery is fully charged. Power on the scanner within radio
range and ensure the status indicator of scanner gives alternating red
and green blinks (in “Uninstall” state). If the scanner is not in uninstall
state, please scan the “Uninstall” command first. Then scan the “HID
Mode” command, and the link indicator of scanner will give 3 blue blinks
per 2 seconds.
Uninstall
HID Mode
Execute the Bluetooth Discovery procedure to find all available Bluetooth
device list in your remote host. You will see ‘’CINO FxxxBT-xxxx’’ is
shown in the list if the scanner is successfully discovered already.
Double click the “CINO FxxxBT-xxxx” in the discovered Bluetooth device
list. If the PIN Code or Passkey is requested for security connection,
please enter “00000000” (default setting). You will see “Keyboard on
CINO FxxxBT-xxxx”, and double click this HID service to establish the
connection between the scanner and the remote host device.
The scanner will give 4 beeps in ascending tone to indicate the radio is
connected. At the same time, the link indicator of scanner will give 1 blue
blink per 2.5 seconds to indicate the scanner is in radio-connected state.
Please note that if the scanner is not connected to the host device within
1 minute after scanning the “HID Mode” command, the scanner will go to
sleep automatically. You just need to press the trigger to wake up the
scanner to continue the installation.
1. The installation procedures vary on different remote host devices,
operating systems and the Bluetooth software drivers. Please consult
your professional IT consultant to obtain necessary support if any
problem has been encountered during the installation processes.
2. While using HID mode, beware of potential error in the data
transmission when radio link quality is poor. You are suggested to use
the scanner under the communication coverage all the time.
6