Ditch Witch SK350 - Manual (Page 30)

SK350 Operator’s Manual
Prepare - 29
Connect Attachment
CMW
Connect Attachment
Attachment
1. Position attachment on level surface with enough
space behind it to accommodate unit.
2. Ensure that lock pin handles (shown) on mount
plate are turned away from center of attachment.
3. Start engine.
4. Tilt mount plate (2) forward.
5. Position mount plate in the upper lip of the receiver
plate (1) on attachment.
6. Raise lift arms while tilting back mount plate.
7. Ensure that all controls are in neutral position.
8. Apply parking brake.
9. Turn ignition switch off and remove key.
10. Rotate lock pin handles toward center of mount
plate to secure attachment to lift plate.
IMPORTANT: Use only Ditch Witch-approved attachments. Attachments can change the stability and
operating characteristics of the unit.
IMPORTANT: Before connecting attachment to unit, ensure that mount and receiver plates are free of
dirt and debris.
IMPORTANT: Attachment should be raised
enough to clear the ground. Mount plate
should be tilted back fully.
NOTICE: To ensure proper connection, verify
that bottoms of lock pins are visible under
attachment receiver plate (shown).
t05om022c.eps
t05om026c.eps
1 2
t05om027c.eps