EXFO FTB-8100 Series Transport Blazer for FTB-500 - Manual (Page 471)

Next-Generation Tabs
SONET/SDH Application 457
GFP Client RX
GFP Client RX
Note: This tab is only available when using External Ethernet.
Press TEST, GFP, and Client (under GFP RX).
External Configuration
Note: External Configuration parameters for both GFP Client TX and RX tabs are
coupled.
³
Interface allows the Ethernet interface type selection. Choices are
Electrical and Optical. The default setting is Electrical unless
otherwise set during the test setup.
Note: Selecting the optical interface automatically turn the interface laser On. To
turn it off, select the electrical interface.
³
Rate allows the interface rate selection. Choices are 1000BaseT Full
Duplex, 100BaseT Full Duplex, and 10BaseT Full Duplex for
electrical interface and, 1000BaseX Full-Duplex for optical interface.
The default setting is 1000BaseT Full Duplex for electrical interface
and 1000BaseX Full Duplex for optical interface.
³
Enable Auto-Negotiation: Allows the auto-negotiation of the port
speed when the rate is set to 100BaseT or 10BaseT. Auto-negotiation is
always enabled for 1000BaseT.