EXFO FTB-8100 Series Transport Blazer for FTB-500 - Manual (Page 86)

Creating and Starting a Test Case
72 FTB-8100 Series Transport Blazer
Typical Test Cases
3. Interface configuration:
3a. Select the Framing, Line Coding, TX
LBO, and RX Termination Mode. Term,
Mon, and Bridge (DS1 only) termination
modes are available. For more
information, refer to TX - DSn Tabs on
page 269 or PDH Tabs on page 369 for the
framing, Port TX (Electrical Interfaces) on
page 138 for Line Coding and LBO, or RX
DSn Tabs on page 269.
3b. Select the Termination Mode for both
RX ports. Dual RX test case uses the BNC
labelled AUX for the second RX port.
3c. For DS1, select the Enable FDL check box to
allow facility data link testing.
3d. For DS1/E1, select the Enable DS0/E0 check
box to allow DS0 or E0 testing.
3e. For DS3 interface, select the Enable FEAC
check box to allow far end alarm and control
testing.
3f. Press Next or Finish.