E-Z-GO EXPRESS L6 - Manual (Page 59)

5 - 7
MAINTENANCE
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
5
Wheel Installation
To reduce the possibility of component damage, do not tighten lug nuts to
more than 85 ft. lbs. (115 Nm) torque.
It is important to follow the ‘cross sequence’ pattern when installing lug nuts. This
will assure even seating of the wheel against the hub.
With the valve stem to the outside, mount the wheel onto the hub with lug
nuts. Finger tighten the lug nuts (1) in a ‘cross sequence’ pattern. Tighten
the lug nuts to 50 to 85 ft. lbs. (68 to 115 Nm) torque in 20 ft. lbs. (27 Nm)
increments following the ‘cross sequence’ pattern.
LIGHT BULB REPLACEMENT
To reduce the possibility of premature bulb failure, do not
touch new bulbs with bare fingers. Use clean, dry tissue
or paper towel to handle the glass portion of the bulb.
For vehicles equipped with lights mounted in the cowl,
locate bulb socket on backside of light and turn bulb
socket a quarter turn counterclockwise to unlock and pull
out bulb and socket. Insert new bulb and rotate socket a
quarter turn clockwise to secure.
Similarly replace the turn signal light bulb, locate bulb
socket on backside of light bar and turn bulb socket a quarter turn counterclockwise to unlock and pull out bulb and
socket. Insert new bulb and rotate socket a quarter turn clockwise to secure.
To replace the tail and brake light bulb, remove hardware securing lens and
remove lens. Install replacement bulb..
Valve Stem Cap
Cross Sequence
Tire style may vary
NOTICE
Inside
of Cowl
Headlight
Bulb
Headlight
Casing
Screw
Rear
Fender
Tail Light
Lens
Tail Light
Bulb
Rear
Fender
Tail Light
Lens
Tail Light
Bulb