E-Z-GO EXPRESS L6 - Manual (Page 60)

MAINTENANCE
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
5 - 8
5
FUSE REPLACEMENT
To replace fuses, locate the fuse block under the driver side seat. Pull out old fuse and replace with a new automo-
tive type fuse. Headlight and taillight bulbs and fuses are available from a local Distributor, an authorized Branch or
the Service Parts Department.
TRANSPORTING VEHICLE
Towing
This vehicle is not designed to be towed.
It is recommended that the vehicle be moved by placing the entire vehicle on a trailer, flatbed truck or other suitable
transport.
Hauling
To reduce the possibility of severe injury or death while transporting the vehicle:
Secure the vehicle and contents.
Never ride on the vehicle being transported.
Always remove the windshield before transporting.
Maximum speed with sun top installed is 50 mph (80 kph).
If the vehicle is to be transported at highway speeds, the sun top must be removed and the seat bottom secured.
When transporting vehicle below highway speeds, check for tightness of hardware and cracks in sun top at mounting
points. Always remove windshield when transporting. Always check that the vehicle and contents are adequately
secured before transporting. The rated capacity of the trailer or truck must exceed the weight of the vehicle (see
GENERAL SPECIFICATIONS for vehicle weight) and load plus 1200 lbs. (544 kg). Secure the vehicle using ratchet
tie downs.
SERVICE AND MAINTENANCE
To reduce the possibility of severe injury or death from improper servicing techniques:
DO NOT attempt any type of servicing operations before reading all notes, cautions and warn-
ings in this manual.
Any servicing requiring adjustments to be made to the powertrain while the motor is running
must be made with both drive wheels raised and vehicle properly supported on jack stands.
To reduce the possibility of motor damage, never operate vehicle at full throttle for more than
4 - 5 seconds while vehicle is in a ‘no load’ condition.
Reduce the possibility of accidental starting by disconnecting battery at negative terminal
before servicing.