Hall Research VSA-51-R - Manual (Page 7)

Digital AV Room Control System
5
2 Hardware
2.1 VSA-51-R
The VSA-51-R is the central component of the VSA-51 hardware installation. The User Interface panel and input
plates connect to the receiver via UTP cable. The receiver also connects directly to the display, audio, and relay
devices.
VSA-51-R Front
1. VGA input #1. Connect to a VSA-V-DP via 2x UTP cables.
2. VGA input #2. Connect to a VSA-V-DP via 2x UTP cables.
3. HDMI input. Connect to a VSA-H-DP via 2x UTP cables.
4. Composite input #1. Connect to a VSA-C-DP via 1x UTP cable.
5. Composite input #2. Connect to a VSA-C-DP via 1x UTP cable.
6. Discrete outputs via Phoenix connector.
7. IR output via 3.5mm jack
(use with Optional IR Emitter Cable Model CIR-EMT).
8. User Interface input. Connect to VSA-UI-DP via 1x UTP cable.
VSA-51-R Rear
9. Power input. Accepts 18-24VDC.
10. IP/LAN for network based configuration and control.
11. Preamp Audio output. Line level via 3.5mm jack.
12. Page Sensor input for optional page sensor kit
(VSA-PGSNS See Section 2.8).