Hanna Instruments HI 903 - Manual (Page 28)

2-4
SETUP
10 Waste Bottle Assembly ............................................. 1 pc.
• Bottle Cap
• Desiccant
• Desiccant Cartridge
• Fittings, O-rings
• Tubes (Silicone and PTFE Tubing)
11 Calibration Key ........................................................ 1 pc.
12 Power Supply .......................................................... 1 pc.
13 USB Cable ............................................................... 1 pc.
14 Instruction Manual Binder ......................................... 1 pc.
15 USB Storage Device ................................................. 1 pc.
16 HI 900 PC Application (Install Kit on USB Stick) ......... 1 pc.
17 Quality Certificate .................................................... 1 pc.
18 ISO 8655 Burette Compliance Report ........................ 1 pc.
19 Karl Fischer Dual Platinum Pin Electrode .................... 1 pc.
See Appendix 3 section A 3 Titrator components for pictures.
If any of the items are missing or damaged, please contact your sales representative.
Note: Save all packing materials until you are sure that the instrument functions correctly.
Any damaged or defective items must be returned in their original packing materials
together with the supplied accessories.
2.2 Safety Measures
The following safety measures must be followed:
1. Never connect or disconnect the pump assembly with the titrator turned on.
2. Verify that the burette and the attached tubing are assembled correctly (see Section 8.1
Burette Maintenance for more details).
3. Always check that the titrant, solvent, waste bottles and the titration beaker are properly
assembled.
4. Always wipe up spills and splashes immediately.
5. Avoid the following environmental working conditions:
• Severe vibrations
• Direct sunlight
• Atmospheric relative humidity above 95% non-condensing