Heath Consultants EyeCGas - Manual (Page 26)

EYE-C-GAS user's manual
Page 26 P/N PS8G9006-Rev 1
www.heathus.com www.opgal.com
5.2.5 Head Set mounting, connection and use
Connect the Head Set to EYE-C-GAS through the Accessories connector located to the right of
the display below the USB2 connector (see Figure 1). Mount the head set on your hard hat as
shown in Figure 23.
For recording audio, speak into the noise cancelling microphone during recording. Audio
recording will automatically be recorded with the video track. The head set performs audio
recording and play back. The head set earphones can be used to listen to embedded recorded
audio from an EYE-C-GAS file and also provides basic hearing protection.
5.2.6 Side straps, neck strap and lens cover
The side straps and neck strap are adjustable to adapt to each user. To adjust the side straps, lift
up the flap, adjust the strap length and push the flap back down again.
It is highly recommended to attach and use the neck strap for hands-free camera transport as well
as user and camera safety.
The lens cover may be attached to one of the side straps when the camera is in use to prevent the
lens cable from being snagged. When the camera is not in use the lens cover must be attached
over the lens to protect the lens.
Figure 23: Head set mounting to the hard hat