Labconco Purifie Horizontal Clean Benches 32000 Series - Manual (Page 10)

Chapter 2: Prerequisites
Product Service 1-800-522-7658 6
Electrical Requirements
The different Purifier XT Clean Bench models have the following electrical
requirements:
All Purifier XT Clean Benches with model numbers ending in -00 are designed
for operation at 115 volts, 60 Hz, alternating current. XT Clean Benches with
model numbers ending in -01 through -04 are designed for operation at 230 volts,
50/60 Hz alternating current. A dedicated outlet with a circuit breaker rated at 20
amps should be located as close as possible to the right, rear side of the bench in
its final location. If your electrical outlet is distant from this location, contact
Labconco’s Product Service Department for information on longer cords.
Do not use any detachable power cord that is not adequately
rated for the unit.
Ne pas utliser un fil électrique amovible qui n’est pas du tension
nominale de l’appareil.
Service Line Requirements
All service lines to the XT Clean Bench should be quarter inch outside diameter,
metal, and equipped with an easily accessible shut-off valve should disconnection
be required. If the service line pressure exceeds 40 PSI, it must be equipped with
a pressure regulator to reduce the line pressure.
The use of flammable gases or solvents should be avoided in
the clean bench. Open flames in the cabinet will disrupt the
laminar airflow in the bench. If you feel that your procedure
requires the use of an open flame or flammable materials,
contact the appropriate safety official.
Model # Requirements
32000 -00 115 VAC, 60 Hz, 10 Amps
32000 -01, -02, -03, -04 230 VAC, 50/60 Hz, 6 Amps
!
Table 2-1
!
!