Lumagen Radiance Mini-3D - Manual (Page 15)

Section 3 – Quick Start Guide
Radiance Mini rev 091211 7
Section 3 – Quick Start Guide
Installation Instructions
1. Install two AAA batteries in the Lumagen Remote Control.
2. Connect the video sources to the HDMI inputs on the receiver (or HDMI Switch).
3. Connect the output of the receiver (or HDMI Switch) to the HDMI Input 1 on the Radiance.
4. Connect the Radiance HDMI output to the display
Default connections for System with AVR plus display/projector
5. Plug the DC power cord from the Radiance power supply into the DC power jack on the back of
the Radiance. Then connect the power cord to the Radiance power supply and plug it into a
wall outlet.
6. Turn the other equipment on and use the Radiance remote control to turn the Radiance on.
7. Select the desired Radiance input using the Radiance remote control. The six video inputs are
numbered 1 to 6 (2 physical and 4 virtual inputs). For all inputs press the “Input” button and then press
the corresponding input number button on the remote.
8. If desired the input selection can be assigned to different physical HDMI inputs. This can be useful if a
receiver or HDMI switcher has several sources and feeds a single input on the Radiance. Different settings
and calibrations for several virtual HDMI inputs can be stored for the same physical inputs. For example,
physical input 2 and virtual inputs HDMI 3 through HDMI 6 can be assigned to physical input HDMI 1. The
command is:
MENU → Input → HDMI Setup → Physical In → (1, 2)
9. Audio inputs can be associated with the active input using the following command:
MENU → Input → Audio Setup → Source → (select audio input) → OK
10. Make sure the appropriate HDMI input on the display/projector is selected, and the selected
source device is outputting active video.
11. You should now have an image on your display/projector. Note: The Radiance automatically
selects the appropriate output resolution and frame rate for HDMI/DVI displays and projectors
(including 24p when supported by the display/projector), when connected according to these
instructions.
12. The default output aspect ratio is 16:9 (i.e. 1.78:1). No output aspect ratio selection is needed
for 16:9 displays or projectors. For other output aspect ratios use the follow command:
MENU → Output → Styles [Style] → Aspect Ratio → (aspect ratio) → OK