Lumagen Radiance Mini-3D - Manual (Page 22)

Section 5 – Video Configuration
Radiance Mini rev 091211 14
or MENU → Output → Styles → [Style] → Aspect Ratio → (Single output aspect, Output aspect
per input aspect) → Ok → xxx → Ok
Graybar Intensity
NOTE:
Consult a home theater specialist for assistance setting the graybar intensity.
Some degree of burn-in will occur on any susceptible display, but this command can help minimize it by allowing
the intensity of the graybars to be adjusted. The command is:
MENU → Output → Styles → [Style] → Graybar → (Sides, Top/bottom)
3D Glasses Adjust
When using the Radiance to control 3D glasses timing this setting adjusts the timing offset of the 3D glasses. This
delay is combined with the global delay setting under the MENU → Other → I/O Setup → 3D Glasses menu.
The command is:
MENU → Output → Styles → [Styles] → 3D Adjust
Misc. Output Settings
3D Output EDID Configuration
By default the display’s 3D capability is automatically detected using its EDID information. However, some 3D
displays do not properly report their 3D capability in their EDID. This command allows the 3D output capability to
be manually set. The command is
MENU → Output → 3D Options→(Off, Auto, On).
Sync Polarity
By default the output sync polarity is selected automatically. This command allows the user to override the
automatic selection for each output. The command is
MENU → Output → SyncPolarity.
Copy Output Settings
This command copies the current output Mode/CMS/Style settings to the selected output Mode/CMS/Style. The
command is:
MENU → Output → Copy→ OK
HDMI Input Setup
After the output is configured, calibrated, and saved, you can calibrate the first input. Note that most often, no
input calibration is necessary. After calibrating the first input, you can copy that configuration to all the other
configuration memories if desired. Then calibrate the other input. To program one of the independent input
memories, select the input, then select the configuration memory and use the menu to configure the input. For
example, if memory A been calibrated and a second configuration is needed, start by copying Memory A to
memory B for that input to reduce setup time for the second configuration.
HDMI Physical Input
If desired the input selection for HDMI sources can be assigned to different physical HDMI inputs. This can be
useful if a receiver or HDMI switcher is used to switch several HDMI to a single input on the Radiance. Different
settings and calibrations for several virtual HDMI inputs can be stored for the same physical inputs. i.e. Physical
input 2 and virtual inputs HDMI 3 through HDMI 6 can be assigned to physical input HDMI 1. The command is:
MENU → Input → HDMI Setup → Physical In → (1, 2)
HDMI Video Type
By default the HDMI input format is detected automatically. For DVI sources that do not report their format, the
input format can be selected manually. The command is:
MENU → Input → HDMI Setup → Type→ (Auto, YCbCr 444, YCbCr 422, RGB)