Lumagen Radiance Mini-3D - Manual (Page 16)

Section 3 – Quick Start Guide
Radiance Mini rev 091211 8
System Configuration Examples
The most common configurations using the Radiance Mini are shown below.
1. Receiver in front of Radiance.
Use a receiver in front of the Radiance to switch the video sources. Connect the display to the Radiance HDMI
Output. The number of video sources that can be connected, is only limited by the number of video inputs on the
receiver. Note: Be aware that some receivers add artifacts to video even if they are in “pass-through” mode.
2. Audio and Video routed separately.
For one or two video sources you can route the audio and video separately to the Radiance and a receiver.
Connect the display to the Radiance HDMI Output.
3. Radiance in small system.
This configuration shows a small system, where the speakers on the display are used for the audio. Two video
sources can be connected to the Radiance. Connect the display to the Radiance HDMI Output.