Luxul XWR-600 - Manual (Page 32)

32
XWR-600
a: 14203 Minuteman Drive, Suite 201, Draper, UT 84020-1685 | luxul.com | 801-822-5450
LUX-UG-XWR-600 Vers: 07814
„
Guest SSID: Displays the current Guest Network settings active on the Router.
w
Enable/Disable SSID: Allows you to Enable or Disable the SSID. Disabled is the
default setting.
w
Network Name (SSID): Allows you to specify the Network Name (SSID) used to
identify the Wireless Network to client devices.
w
SSID Broadcast: Allows you to Enable or Disable the SSID Broadcast. Enabled is the
default setting.
w
Security Mode: Allows you to set the desired Security Mode used to con-
nect to the SSID. Supported modes include 64bit/128bit WEP, WPA, WPA2 and
WPA/WPA2 Mixed. Open is the default setting. Adding Security to any SSIDs is
recommended.
w
WEP Key: When selecting WEP Security a WEP key option will appear. This allows
you to set the WEP Key. It can consist of Numbers 0-9 and Letters A-F. For 64bit
WEP, enter 10 hexadecimal digits (0-9 and A-F) or 5 regular characters. For 128bit
WEP, enter 26 hexadecimal digits (0-9 and A-F) or 13 regular characters.
w
Encryption: When selecting WPA or WPA2 security, two new options will appear.
The first is Encryption, which allows you to set the Encryption type used by WPA/
WPA2. Options include AES, TKIP&AES and TKIP. AES is the default and recom-
mended setting.
w
WPA Passphrase: When selecting WPA or WPA2 security two new options will
appear. The second is WPA Passphrase, which allows you to set the Passphrase used
to connect to the SSID. WPA Passphrases must be a minimum of 8 to a maximum
of 63 Characters and can contain Letters (capitol and lowercase), Numbers, Special
Characters and Spaces.
„
Guest DHCP: Displays the Guest Network DHCP Server settings of the Router.
w
Enable DHCP Server: Allows you to Enable or Disable the Routers DHCP Server.
Enabled is the default setting.
„
DHCP Range: Displays the DHCP Pool settings of the Router. Settings can be viewed
or modified here.
w
Start: Allows you to set the Starting IP Address of the DHCP Pool. 192.168.10.100 is
the default setting.
w
End: Allows you to set the Ending IP Address of the DHCP Pool. 192.168.10.200 is the
default setting.
w
Lease Time (hours): Allows you to set the number of Hours for which the DHCP
Lease issued to the Client Device is valid before requiring a DHCP Renew. 12 Hours
is the default setting.