Luxul XWR-600 - Manual (Page 34)

34
XWR-600
a: 14203 Minuteman Drive, Suite 201, Draper, UT 84020-1685 | luxul.com | 801-822-5450
LUX-UG-XWR-600 Vers: 07814
„
Port Forwarding: Allows you to open public Ports to allow access to the private Port
of a local device. Port Forwarding opens a hole in the Firewall to the specified Local
Network device. Port Forwarding relies on the security of the Local Network device
as it merely allows the incoming connection to reach the Local Network device.
w
Application Name: Allows you specify a Name for the Port Forwarding rule for
easy identification. Special characters or spaces in the Application Name are
not recommended.
w
Protocol: Allows you to specify whether to use TCP, UPD or Both protocols to pass
the Port Forwarding traffic. Both is the default and recommended setting.
w
WAN Port: Allows you to specify the Public Port to be opened. This Port will
match the LAN Port in most configurations. The WAN Port does not need to match
the WAN Port, allowing you to serve Multiple devices on the Local Network on the
same Port (i.e. 80) with differing WAN Ports (i.e. you have three devices that serve
over Port 80. You can set the first WAN Port to 80, the second to 81 and third to
82). The WAN Port can also be different if the LAN Port is well known (i.e. 80, 443,
59, 22, etc…) and you wish to hide it behind a less well known port (i.e. 5001).
w
LAN IP: IP Address of the Local Network device you are Port Forwarding too.
w
LAN Port: The Local Network Port served by the Local Network device, typically
the same as the WAN Port.
w
Add: Click the Add button to add your Port Forwarding Rule to the Port
Forwarding Table. This also Saves the Port Forwarding settings, allowing you to
browse to another page in the Router before rebooting to apply the changes.
„
Port Forwarding Table: Displays the configured Port Forwarding Rules.
w
Application Name: Displays the Application Name of the Rule.
w
Protocol: Displays the permitted Protocol of the Rule.
w
WAN Port: Displays the WAN Port specified for the Rule.
w
LAN IP: Displays the IP Address of the Local Network device to which incoming
traffic will be redirected.
w
LAN Port: Displays the Port of the Local Network device to which incoming traffic
will be redirected.
w
Remove: This button allows you to Delete the selected Port Forwarding Rule and
Saves the changes, allowing you to browse to any other setup page.
NOTE: After Adding a Port Forwarding Rule your settings are Saved, then you
must click the Reboot button for the changes to take effect. You can
click the Add button and proceed to other pages without losing your
configured changes.