Luxul XWR-600 - Manual (Page 40)

40
XWR-600
a: 14203 Minuteman Drive, Suite 201, Draper, UT 84020-1685 | luxul.com | 801-822-5450
LUX-UG-XWR-600 Vers: 07814
NOTE: Please back up any configuration before performing a
Firmware Update.
3.7.3 Factory Defaults
This page displays the Factory Defaults and WAN Acceleration Status of the Router.
Select the menu Administration>>Factory Defaults to display the following page:
„
Factory Defaults: Displays the Factory Default action.
w
Restore Factory Defaults: Allows you to Restore the Router to Factory settings.
Click the Reset & Reboot button to perform the Restore. Do not Power Down the
Router during this process as Restore failure may result.
„
WAN Acceleration Status: Displays the current WAN Acceleration Status.
w
WAN Acceleration: Allows you to Enable or Disable WAN Acceleration. Enabled
is the default setting. WAN Acceleration allows the Router to pass packets at near-
wire speeds on Internet connections exceeding 120Mbps.
w
Save: This button is used to Save the configuration changes made on this page.
Once you have clicked Save in WAN Acceleration you do not need to reboot the
Router. WAN Acceleration can take up to two minutes to become active.
NOTE: Factory Defaults will remove any custom configuration
options configured on the Router. It will not remove
Firmware Updates.
NOTE: If after Enabling WAN Acceleration your Internet connection
becomes unstable, please Disable WAN Acceleration.