Martin Christ Epsilon 2-6D LSCplus - Manual (Page 82)

Freeze-dryer EPSILON 2-6 LSCplus
6 Operation
82
Version 10/2012, Rev. 1.6 of 16/12/2014 • sb
Translation of the original operating manual
6.5.3.2 Editing a program
An existing program can be modified as long as it has not been loaded.
• Select the program to be edited from the list in the main window
“Program”.
• Press the button with the program name in order to call up a window
that displays the program data.
• Perform the desired modifications and save the program (see chapter
6.5.3.1 - "Creating a program").
• Close the dialog box by pressing the “Program” button.
The program has now been changed in the existing program storage
location.
NOTE
It is possible to switch to the manual mode during a program run, e.g. in
order to edit a program during the runtime. The point of time for continuing
the program run can be defined by selecting the desired start section and
a start time.
Pos: 154 /01 0 Univ ersal mod ule/L eerz eile @ 0\m od_ 120 211 624 450 0_0. docx @ 11 4 @ @ 1
Pos: 155 /20 0 Ch rist/3 60 G T-BA L abo r-Pilot (STANDARDMODU LE)/0 60 Bet rieb/ LSCplus/ 060 -00 50- 003 3-0 030 Prog ra mm k opie ren @ 25 \mo d_1 404 984 0012 22_ 68. docx @ 183 998 @ 4 @ 1
6.5.3.3 Copying a program
If a new program is to be created based on an already existing program,
the already existing program can be copied. A free program storage
location must be available for this purpose.
• Select the program to be copied from the list in the main window
"Program".
• Press the button with the program name in order to call up a window
with the program data.
• Press the button “Copy program” in order to create a copy of the
existing program.
• Edit and save the copy (see chapter 6.5.3.1 - "Creating a program").
• Close the dialog box by pressing the “Program” button.
The program will be automatically assigned to the first free program storage
location.
Pos: 156 /01 0 Univ ersal mod ule/L eerz eile @ 0\m od_ 120 211 624 450 0_0. docx @ 11 4 @ @ 1
Pos: 157 /20 0 Ch rist/3 60 G T-BA L abo r-Pilot (STANDARDMODU LE)/0 60 Bet rieb/ LSCplus/ 060 -00 50- 003 3-0 040 Prog ra mm la den @ 2 5\m od_ 1404 984 002 690 _68. docx @ 18 401 2 @ 4 @ 1
6.5.3.4 Loading a program
If a freeze-drying process is to be executed and controlled by a program,
the program must be loaded.
• Call up the main window "Program". This window includes a list of all
the programs that are saved.
• Press the button "Load" behind the program name. A dialog box will be
displayed in which the start section, the start time or the start
temperature can be adapted to any specific needs. The "Info" button
can be used to call up a brief description of the active program,
including information concerning the remaining runtime and the end of
the program. It also enables a graphical representation of the process
sequence.