Mighty Mule FM502 Dual Swing - Blue Board User Manual
Page 44
40
If you have a question about any special order item,
just call 1-800-543-GATE!
Accessories are Available From Your Retail Store (con't)
The contents of all material available on this installation manual are copyrighted by Gates That Open, LLC (“GTO”), unless otherwise indicated. All rights are reserved by GTO, and content may not be repro-
duced, downloaded, disseminated, published, or transferred in any form or by any means, except with the prior, written permission of GTO. Any reprinting of GTO publications is by permission only. Copyright
infringement is a violation of federal law.
Mighty Mule¨, E-Z Gate¨, GTO¨, are registered trademarks of Gates That Open, LLC America’s DIY Automatic Gate Openers is a trademark of GTO and are the exclusive property of Gates That Open, LLC.
All rights are reserved by GTO, and these marks may not be used, in any for without the prior, written permission of GTO.
POW
ER
Key
pad
Bat
t Lo
w
Gran
t
Perm
issio
n
An
sw
er
DV 9V
ACC
ES
S
CONTR
OL
SYS
TE
MS
1-
80
0-5
43
-4
28
3
11" Push to Open Bracket (FM148)
Required when Mighty Mule® 500/502 gate operator(s) must push the gate open, such as on a sloping driveway or
where space prevents gate(s) from opening inward (pulled open). Order two PTO brackets for conversion of a dual
swing gate installation.
Column Mount Lock Receiver (433IH)
For mounting the Automatic Gate Lock on brick columns, walls, or for other applications with limited space
between gate and post.
Replacement Transformer (RB570)
Standard 18 volt, 2200 mA, AC transformer for maintaining the battery included with the Mighty Mule®
gate operator. This is the only transformer approved for use with all UL325 Mighty Mule® gate operator systems.
Garage Door Receiver (RB709U)
The Garage Door Receiver allows you to use the same Mighty Mule® entry transmitter (see Dual Transmitter) to
operate your gate operator and your garage door operator. Compatible with most garage door operators.
Wireless Entry Intercom / Keypad (FM136)
Allows owner to screen guest at the gate before allowing access to the property. Keypad also allows owner
to give up to 25 programmable entry codes to family, friends or approved delivery personnel. Codes can be
permanent of temporary. Can be wireless up to 500 feet or hard wired up to 1000 feet. Additional base stations
available (F3101MBC).
Replacement Battery (FM150)
Standard 12 volt, 7.0 amp-hour, maintenance-free battery for the Mighty Mule® FM500 & FM502 gate
operator systems. This is the only battery approved for use with the Mighty Mule® FM500 & FM502 gate
operator systems. Life expectancy is 3-5 years.
Low Voltage Wire (RB509)
The 16 gauge, multi-stranded, dual conductor Low Voltage Wire is for connecting the AC powered
transformer, or the Solar Panel to the control board. Also used for the connection of accessories, such as locks,
keypads, push buttons and other wired control devices. This specially designed wire is UV treated, PVC coated
and ready for direct burial. Available in 50, 100, 250, 500 and 1000 foot rolls.