Peg-Perego Primo Viaggio Convertible - Manual (Page 29)

- 29 -
Installing your child restraint in the vehicle - Rear Facing mode
5. Attach the lower connectors to the lower
anchors of your vehicle located at the joint
line between seat and backrest. Check your
vehicle owner’s manual to learn what is the
best place for your child restraint. When the
LATCH straps are connected to the lower
anchors, an audible click will be heard. If
this is not the case, repeat the operation
and double check that the latch is attached
and working by trying to pull the lower
connector away from the lower anchor.
6. Push down the child restraint (A) into
the seat with your own body weight and
at the same time pull the strap ends in
order to tighten the latch straps (B). Check
that the connectors are evenly tightened
and that the seat is not leaning sideways.
7. Picture shows the correct strap path
when the seat is attached using the
LATCH connectors. Make sure the seat is
properly leveled as explained on page 27.
Verify that the child restraint is secure.
A secure child restraint will not move
more than 1 inch near the latch anchors.
5
A
B