Peg-Perego Primo Viaggio Convertible User Manual
Page 42
- 42 -
Installing your child restraint in the vehicle - Forward Facing mode
Important! Remove newborn filler cushion
in forward facing mode (see page 55).
FORWARD FACING MODE USING
LAP/SHOULDER
BELT
(TYPE
II)
1. Before installing the child restraint, make
sure that the backrest is in the upright position
or adjust it using the handle below the front
edge of the shell (A) as shown in detail.
2. Lean the upright child restraint,
unoccupied, on the selected vehicle seat.
Make sure that the LATCH straps are stored
in their proper location (page 39 - picture2)
and that the rear openings in the structure
are free and ready for use. Open the lock off
clips on both sides as shown in the picture.
3. Pull the vehicle belt at full available
length and thread both the lap and
shoulder portions of the belt through
the openings in the structure behind the
child restraint as shown in the picture.
4. Buckle the vehicle belt and check that
the vehicle belts are both threaded through
the openings, free of any entanglement.
4
3
A
A
B
1
2