Peg-Perego Primo Viaggio Convertible - Manual (Page 39)

- 39 -
Installing your child restraint in the vehicle - Forward Facing mode
Important! Remove newborn filler cushion in
forward facing mode (see page 55).
FORWARD FACING MODE USING
LATCH SYSTEM
1. Recline the child restraint pulling the
handle located below the front edge of the
shell (A) as shown in detail. This will make
access to the latch storage area easier.
2. Disconnect the latch straps from the
storage bar by pushing on the red button
and pulling the straps at the same time.
3. Pull the handle and move the child restraint
to the upright position. You should hear a "click"
when locked in the upright position. Lean the
child restraint on the vehicle seat making
sure that the lock off clips are closed.
Take the LATCH strap from front to rear
sliding the straps along their tubing.
1
A
A
B
3
2