Rocktron Utopia B300 - Manual (Page 49)

49
FUNCTION PARAMETER LIST RANGE
(via FUNCTION SELECT) (via PARAMETER SELECT) via PARAMETER ADJUST)
TAP QUANTIZING DELAY 1 Sixteen, Eighth, Triplet, Quarter,
Half, Whole, None
DELAY 2 Sixteen, Eighth, Triplet, Quarter,
Half, Whole, None
REVERB REV INPUT (Reverb Input Status) Muted, Active
MIX (Direct/Delay Mix Level) Dir <0 to 100> Dly
REVERB LVL (Reverb Signal Level) OFF to +4(dB)
REV DECAY (Reverb Decay Length) 0 to 99
REV HF DAMP (Reverb High Frequency Damping) 0 to 99
PEDAL NUMB 1 ADJ, IPED, IPSW, XPED, OFF
CONTROLLERS PARA1 Any parameters available in this
configuration can be selected.
ULIM C1 Any range in PARA1's selection
can be used.
LLIM C1 Any range in PARA1's selection
can be used.
NUMB 2 ADJ, IPED, IPSW, XPED, OFF
PARA 2 Any parameters available in this
configuration can be selected.
ULIM C2 Any range in PARA2's selection
can be used.
LLIM C2 Any range in PARA2's selection
can be used.
NUMB 3 ADJ, IPED, IPSW, XPED, OFF
PARA 3 Any parameters available in this
configuration can be selected.
ULIM C3 Any range in PARA3's selection
can be used.
LLIM C3 Any range in PARA3's selection
can be used.
PEDAL STATUS RUN STAT (Pedal Running Status On or Off) OFF,ON
PEDAL VOLUME 0 to 127
FOOTSWITCH EFX 1 Compressor, Solo, TBypass
MAPPING TOGGLE Deep, Norm, Brite, Dist
MIDI CHANNELS RECEIVE 1-16-OMNI, OFF (default is Omni)
TRANSMIT 1 -16, OFF (default is OFF)
MIDI DUMP/LOAD 1 PR DUMP/LOAD (1 Preset Dump/Load)
BULK DUMP/LOAD
FACTORY RESTR X to X (Restore a single preset) 1 to 1, 2 to 2, 3 to 3, etc.
RESTORE ALL RESTORE (Restore all factory presets) Enter Number 22 - Use caution
as this will over-write all presets!
VERSION NUMBER
TITLE EDIT XXXXXXXXX
7. Function - Parameter - Range List continued.....