Rocktron Utopia B300 - Manual (Page 63)

63
PROG CH TX ON, MAP, OFF DEFAULT = OFF
1 -TX-PC-> 127 [PROGRAM TRANSMIT MAP]
Note: The TRANSMIT CHANNEL must be assigned found in MIDI CHANNELS function so the
B300 can send out MIDI MESSAGES.
The B300 can send PROGRAM CHANGES to another MIDI capable device through the MIDI OUT/
THRU jack whenever you recall a preset . You may send any PROGRAM CHANGE number you de-
sire adding extra flexibility when controlling a favorite piece of outboard gear.
PROG CH TX
ON The B300 will send PROGRAM CHANGES on a 1 to 1 basis.
If you recall PRESET 1 on the B300 it will send PROGRAM CHANGE 1 on the
assigned TRANSMIT CHANNEL .
MAP When set to MAP the B300 will send a different PROGRAM CHANGE NUMBER you
have selected to be sent using the 1 -TX PC→ 127 mapping !
Default mapping is 1 to 1.
HOW TO MAP PRESETS:
Using the 1 -TX PC→ 1 when you recall preset 1 it could send PROGRAM CHANGE 127
when set as 1 -TX PC→127
To MAP the -TX-PC→ is easy and here’s how you do it.
1. Turn the FUNCTION SELECT to PROGRAM CHANGES FUNCTION.
2. Use the PARAMETER SELECT CONTROL to select the -TX-PC display
3. To pick the preset to be mapped [ The preset you will recall ] TURNING the PARAMETER
SELECT will scroll 1,2,3,4,5,6, etc……
4. Now use the PARAMETER ADJUST to select the PRESET NUMBER you want sent out from
the B300.
EXAMPLE:
B300 1 -TX-PC→13 [RECEIVING DEVICE]
5. Once you have set this PRESS STORE to complete the mapping process for that preset. The
display will show “ STORED “ to indicate success.
Note: Every changed mapping needs to be stored before advancing to the next B300 preset us-
ing the PARAMETER SELECT.
8. Program Changes: