Rocktron Utopia B300 - Manual (Page 58)

58
Step 2
c
*
Step 1 Enter the turner mode using one of the 2 methods described below:
Method 1: After recalling any preset. Press and hold the preset button again. The
B300 after a few seconds will automatically activate the TUNER. You will notice the
MUTE TUNER red LED is on and the tuner is active. Once you have finished tun-
ing PRESS the MUTE/TUNER footswitch to return to the preset you were currently
using.
Method 2: After recalling any preset. Press the preset button again to enter 2nd Mode.
You may choose to use the other switches to control other things before using the
tuner. When you want to use the tuner within 2nd Mode….Press the MUTE / TUNER
footswitch #3 to activate the TUNER.
You will notice the MUTE TUNER red LED is on and the tuner is active. Once you
have finished tuning PRESS the MUTE/TUNER footswitch to return to the preset you
were currently using.
Pluck the harmonic at the 12th fret of the string you intend to tune. The B300 will de-
tect the note and indicate its nearest even tempered pitch at the center of the display.
If the note is slightly above or below any of the 12 even-tempered notes, a sharp or
flat condition is indicated by an asterisk symbol in the bottom line of the display at
either side to the displayed note as shown below:
c
*
FLAT SHARP
The Utopia B300 provides a built-in harmonic tuner which can be activated 2 different ways at any
time. This will MUTE the output of the B300 allowing you to tune in silence. Use 12th fret harmonics
to tune.
8. MUTE/ Harmonic Tuner Function