Spectrum Controls 1762sc-IF8U - Manual (Page 11)

User's Manual Pub. 0300243‐02 Rev. B
Chapter 2
Installation and Wiring
This chapter will cover:
 Compliance to European union directives
 Power requirements
 General considerations
 Mounting
 Field wiring connections
 Module Indicators
Section 2.1
Compliance to
European
Union Directives
This product is approved for installation within the European Union and EEA regions. It
has been designed and tested to meet the following directives.
2.1.1 EMC Directive
The 1762sc-IF8u module is tested to meet Council Directive 89/336/EEC
Electromagnetic Compatibility (EMC) and the following standards, in whole or in part,
documented in a technical construction file:
 IEC 61000-6-4 Electromagnetic compatibility (EMC) - Part 6-4: Generic
standards - Emission standard for industrial environments
 IEC 61000-6-2 Electromagnetic compatibility (EMC) – Part 6-2: Generic
standards – Immunity for industrial environments
This product is intended for use in an industrial environment.
2.1.2 Low Voltage Directive
This product is tested to meet Council Directive 73/23/EEC Low Voltage, by applying
the safety requirements of EN 61131-2Programmable Controllers, Part 2 – Equipment
Requirements and Tests. For specific information required by EN61131-2, see the
appropriate sections in this publication, as well as the following Allen-Bradley
publications:
 Industrial Automation, Wiring and Grounding Guidelines for Noise Immunity,
publication 1770-4.1
 Automation Systems Catalog, publication B113
Section 2.2
Power
Requirements
The module receives power through the bus interface from the +5V dc/+24V dc system
power supply. The maximum current drawn by the module is shown in the table below.