Spectrum Controls 1762sc-IF8U - Manual (Page 16)

2-6 MicroLogix™ 1200 IO Universal Input Module
User's Manual Pub. 0300243‐02 Rev. B
Note: For environments with extreme vibration and shock concerns, use
the panel mounting method described below, instead of DIN rail mounting.
2.4.3 Panel Mounting
Use the dimensional template shown below to mount the module. The preferred
mounting method is to use two M4 or #8 Pan Head screws per module. M3.5 or #6 Pan
Head screws may also be used, but a washer may be needed to ensure a good ground
contact. Mounting screws are required on every module.
Figure 2-3
Section 2.5
System
Assembly
The expansion I/O module is attached to the controller or another I/O module by means
of a ribbon cable after mounting as shown below.
Figure 2-4
Note: Use the pull loop on the connector to disconnect modules. Do not
pull on the ribbon cable.