Spectrum Controls 1762sc-OF8 - Manual (Page 20)

2-10 MicroLogix™ 1200 IO 8 Ch Output Module
User’s Manual Pub. 0300246-01 Rev. B
Figure 2-7 (Door Label)
Section 2.7
Module Indicators
The 1762 output module uses a single green LED to show operational status of the
module. The LED will illuminate solid when the PLC is in run mode and the module
properly configured. If the module is not properly configured, or if the PLC is not in run
mode, the LED will blink rapidly. The following blink codes are the only exception:
Table 2-2 (LED Blink Codes)
Blink Code Description
Rapid Blink 5 PLC not in run mode, or no valid module configuration present
Solid Module is in run mode (Normal Operation)
3 Factory calibration in progress
4 Factory calibration invalid
5 Module is in command mode
5
All outputs are disabled until the PLC goes into run mode and the module receives a valid configuration.