Taser CAM-HD - Manual (Page 10)

TASER CAM HD Recorder
MMU0036 Rev: B Page 10 of 48
The AS recorder provides an audible beeping alert for the last two seconds of
a trigger-activated firing cycle before automatically shutting down the cycle.
There are two ways your agency may have configured your ECD to work with
the TASER CAM HD AS recorder. With one option, shut down will occur 5
seconds after a trigger-initiated energy burst, but ARC switch functioning will
not be affected. With the other option, shut down will occur after 5 seconds
whether you press the trigger or the ARC switch.
Note: TASER CAM HD AS feature has no impact on video and audio
recording; however the audio alert will be captured on the recording
and may distort any audio captured from the incident during the
duration of the audio alert. As long as the safety switch is in the up
(ARMED) position, the TASER CAM HD AS will continue to capture
the event.
Under stressful situations, audio exclusion might prevent you from
hearing the alert from the automatic shut-down TASER CAM HD
recorder.
Your ECD recognizes the TASER CAM HD AS as a unique type of battery
pack which enables the automatic shut-down feature of the ECD. The ECD
will indicate that this feature is enabled via a special TASER CAM HD AS
icon in the upper left hand corner of the ECD CID as shown below:
This feature is automatically disabled if replaced by another battery pack
type, and the X2 ECD will return to its normal configuration (that is, there will
no longer be an audio alert, and the energy cycle will continue after 5
seconds if your finger is still holding down the trigger or ARC switch). Always
confirm that the ECD performs as expected before returning it to duty after
changing any battery pack.
Remove the cartridges before testing the ECD function. See the
Unloading section in the TASER X2 ECD User Manual for more
information.