Taser CAM-HD - Manual (Page 12)

TASER CAM HD Recorder
MMU0036 Rev: B Page 12 of 48
Chapter 3: Charging the TASER CAM HD
Recorder
Note: Ensure that you fully charge the TASER CAM HD recorder before the
first use (before it is inserted into an X2 ECD).
For any subsequent charging performed with the recorder inserted in
the ECD, ensure that the safety switch is in the down (SAFE) position
and that the Smart cartridges are removed from the ECD. See the
TASER X2 ECD Operating Manual for more information.
After the initial charging cycle is complete, there are two ways to recharge the
TASER CAM HD recorder, through a: (1) wall power charging cable; or (2)
PC USB download cable. Depending on the amount of charge in the battery,
it may take up to 5 hours for the TASER CAM HD recorder to fully charge.
Charging can be accomplished with the TASER CAM HD recorder in the X2
ECD or independently (with the TASER CAM HD recorder out of the X2
ECD).
Charging the TASER CAM HD Recorder Using the Wall Power
Charging Cable
1. Remove the data port plug from the bottom of the TASER CAM HD
recorder.
2. Connect the wall power cable to the TASER CAM HD recorder.
Note: When inserting the power cable, it is important that the gold tabs
face forward toward the camera lens.
3. Connect the wall power cable to a wall outlet.