Taser CAM-HD - Manual (Page 29)

TASER CAM HD Recorder
MMU0036 Rev: B Page 29 of 48
Chapter 8: Firmware Update
It is important that your X2 ECD has firmware revision V03.022 or later when
using it with the TASER CAM HD recorder. (See the TASER X2 ECD User
Manual for instructions on determining
your ECD’s firmware revision.)
If you have not installed the EVIDENCE Sync software, follow the Chapter 5:
Configuring the TASER CAM HD Recorder with EVIDENCE Sync Software
instructions before performing any of the procedures in this chapter.
If your X2 ECD does not have V03.022 or higher and you have an
EVIDENCE.com account, follow the First-Time ECD Firmware Update –
Online instructions.
If your X2 ECD does not have V03.022 or higher and you do not have an
EVIDENCE.com account, follow the First-Time ECD Firmware Update
–
Offline instructions.
If your X2 ECD has V03.022 or higher and you have an EVIDENCE.com
account, follow the Recorder and ECD Firmware Update
– Online
instructions.
If your X2 ECD has V03.022 or higher and you do not have an
EVIDENCE.com account, follow the Recorder and ECD Firmware Update
– Offline instructions.
First-Time ECD Firmware Update
– Online
1. Confirm that the safety on the X2 ECD is in the down (SAFE) position.
2. Remove the Smart cartridges. (See the TASER X2 ECD User Manual
for more information on unloading Smart cartridges.)
3. Insert an X2 download cable into the ECD.
4. Start your EVIDENCE Sync software.
5. Type your username and password and click SUBMIT.