Turning Technologies TurningPoint 5 - Manual (Page 15)

TurningPoint 5 for Mac 15
Prerequisites
Ensure the receiver is properly installed (if using
ResponseCards) and the compatible response
device to be tested is available.
1 If using ResponseCards, plug in the
receiver, open TurningPoint and click the
channel number below Receiver. If using
ResponseWare, open TurningPoint and
click the Session ID below
ResponseWare.
The Preferences window opens.
2 Click Test.
The Polling Test window opens.
There are three columns in the polling test window.
l
Device ID - Displays the Device ID of the response device. A count of the devices that have responded are also
displayed next to the Device ID column header.
l
Source - Displays the serial number of the receiver.
l
Response - Displays the response sent from the response device.
3 Press a button on the response device.
For ResponseCard users, if the receiver and response device are set to the same channel, the response will appear in
the polling test. For ResponseWare users, the ResponseWare Device ID will appear in the polling test.
4 Click Close when finished with the polling test.
5 Click Close on the Preferences window.
Pairing a PresenterCard
A PresenterCard must be paired with TurningPoint before it can be used as a presentation device. If you do not have a
PresenterCard, skip this task.
turningtechnologies.com/user-guides