Connection to receiver, Hitec，futaba，（wfly）wiring, Jr，spektrum wiring – XAIRCRAFT Super X User Manual
Page 13: Connect to other receiver
10
©2013 XAircraft All Rights Reserved.
Connection to Receiver
HITEC，FUTABA，（WFLY）Wiring
Restore factory settings of the radio,
then do the settings as below:
Reverse 1, 2, 3, 4 channels, other
channels can be set according
to your habit.
Map 5th channel to a 3-way
switch.
Map 6th channel to a 2-way
switch, and set fail-safe as
Safe
Mode
section described.
Map 7tn channel to a knob.
JR，Spektrum Wiring
Restore factory settings of the radio,
then do the settings as below:
Set fail-safe as
Safe Mode
section described for Gear.
Map AUX1 to a 3-way switch.
Map AUX2 channel to a knob.
Connect to other Receiver
Please consult with
to do wiring, and then do the RC calibration.
Notice:
You may need to
change the reverse setting on radio before use SuperX, be careful during
tuning SuperX.