XAIRCRAFT Super X - Manual (Page 19)

16
©2013 XAircraft All Rights Reserved.
2. Push both sticks to top right as diagram shows, the LED show triple green flashing.
3. Keep both sticks on top right, fast altering Flight Mode switch until led solid green, calibration
done.
4. Repower on.
Flight Control
Motor Start / Stop
Follow diagram as below: Push sticks both down-inside or down-outside to start motors, then
motors are running slowly. If the motors do not start after the operation, please check wiring of
receiver and reverse setting of radio.
Motor will stop under conditions below:
1) After motors started, if there is no pushing throttle in 3 seconds, another
down-inside/down-outside operation can stop the motors immediately.
2) When copter already landed and throttle down to lowest, motors stop immediately.
3) When copter still in the air and throttle down to lowest, motors will stop in 3 seconds.
Notice: After motors stopped in the air, you can push throttle to restart the motors in 3 seconds.
The conditions motor cannot be started:
1) LED shows red or flashes red.
2) LED shows yellow with the weak interference of magnet in GPS Mode.
3) Not connect with receiver in a right way or not calibrate RC reverse correctly.