Manually activate safe mode fail-safe setting, Manually activate safe mode, Fail-safe setting – XAIRCRAFT Super X User Manual
Page 22
19
©2013 XAircraft All Rights Reserved.
1. Return to home and landing(tail in): copter turns its tail towards home (H) and then lifts up
to 15m height (relative home point H), then returns to home and land.
2. Return to home and landing (nose in): copter turns its head towards home (H) and then lifts
up to 15m height (relative home point H), then returns to home and land. This option is
suitable for FPV.
3. Hovering: Copter will hold its position and wait for your
control
.
4. Landing: Copter will auto-land when the Safe Mode is activated.
Manually Activate Safe Mode
Turn on Safe Mode through the Safe Mode switch on radio, and then LED shows Safe Mode.
If LED does not indicate Safe Mode, please check remote control settings and the wiring of
receiver.
Fail-safe Setting
Set Fail-safe on radio to make the receiver outputs “safe mode on” signal for Flight Controller
when RC signal is lost.
Check: After setting fail-safe, should power on SuperX and turn off the transmitter, then the LED
shows Safe Mode. If LED does not indicate Safe Mode, please check radio settings again.