Abbott Freestyle Freedom Lite - Manual (Page 15)

11
5.
Apply and hold blood to 1 sample area of the test strip until:
•
You see short lines moving clockwise on the display or
•
You hear a beep
This indicates the test strip obtained enough blood and the meter is checking
your glucose level . If a short line does not appear after 5 seconds, the sample may
be too small . You can add blood to the same side only for up to 60 seconds . If the
test does not start after applying blood drop, go to Troubleshooting section .
(Example only)
6.
View result
The result appears on the display when the test is complete . The time that the
meter takes to display a result depends on your blood glucose level . Higher
glucose levels require more time .
Note: If you see an “Er1, Er2, Er3, or Er4” on the display, it is an error code . Go to
Error Codes section .
7.
Remove test strip to turn meter off .
Discard used lancet and test strip properly .
8.
Wash your hands and test site thoroughly with warm water and soap after
handling the meter, lancing device or test strips .
Contact Customer Care Toll Free at 1-888-522-5226 www.MyFreeStyle.com
English