Pilz PIT m3.1p - Manual (Page 34)

7.5 Troubleshooting
7 Operation
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
7-6
7.5 Troubleshooting 7500 Troubleshooting 7- Fehlerbehebung BAWS
If an error occurs on the operating mode selector switch, the last oper-
ating mode to be set will be retained.
Error Possible cause Remedy
Unable to switch the operating mode Multiple operation of buttons Make sure that only one button is op-
erated.
... Operating time too long or too short Make sure that the period of operation
is observed.
... Actuator is not detected Make sure that the actuator is con-
nected to the operating mode selector
switch correctly.
... No valid authorisation Make sure that the relevant actuator is
used.