Mini 2010 Cooper Convertible User Manual
Page 133
131
>
Filling the tire with sealant
>
Distribute the sealant
>
Correct the tire inflation pressure
Filling the tire with sealant
Proceed in the specified order; otherwise,
sealant may emerge under high pres-
sure.
<
1.
Shake the sealant bottle.
2.
Pull the connection hose 9 out of the com-
pressor housing fully and screw it onto the
connector of the sealant bottle. Make sure
that the hose is not kinked.
3.
Insert the sealant bottle on the compressor
housing in an upright position.
4.
Unscrew the dust cap from the valve of the
defective wheel and screw the filling hose 2
of the sealant bottle onto the valve.
5.
Ensure that the compressor is switched off.
6.
Insert the plug 3 into the lighter socket/
power socket in the vehicle interior,
page
.
7.
With the engine running:
Switch on the compressor and let is run for
approx. 3 to 8 minutes to fill the tire with
sealant and achieve a tire inflation pressure
of approx. 26 psi/180 kPa.
When filling the tire with sealant, the
inflation pressure can briefly rise to
approx. 73 psi/500 kPa. Do not switch off
the compressor during this phase.
<
Do not run the compressor for longer
than 10 minutes; otherwise, the
device will overheat and possibly be dam-
aged.
<
8.
Switch off the compressor.
If an air pressure of 26 psi/180 kPa is not
reached:
1.
Unscrew the filling hose 2 from the wheel
and drive the vehicle forward and backward
approx. 33 ft/10 m to distribute the liquid
sealant in the tire evenly.
2.
Inflate the tire again with the compressor.
If an inflation pressure of 26 psi/180 kPa
still cannot be reached, the tire is too
heavily damaged. Please contact the nearest
MINI dealer.
<
Stowing Mobility System
1.
Unscrew filler hose 2 of the sealant bottle
from the wheel.
2.
Unscrew connecting hose of the
compressor 9 from the sealant bottle.
3.
Connect the filler hose 2 of the sealant bot-
tle to the unoccupied connection on the
sealant bottle.
This prevents the rest of the sealant from
escaping from the bottle.
4.
Wrap the empty sealant bottle in suitable
material to avoid dirtying the cargo bay.
5.
Stow Mobility System back in the vehicle.
Distributing the sealant
Immediately drive approx. 3 mls/5 km to evenly
distribute the sealant.
Do not exceed speeds of 50 mph/
80 km/h.
If possible, do not drop below 10 mph/
20 km/h.
<
Correcting the tire inflation pressure
1.
After driving approx. 3 mls/5 km or ten min-
utes, stop at a suitable location.
2.
Screw the connection hose 2 of the com-
pressor directly onto the tire valve.
3.
Insert the plug 3 into the power socket in the
vehicle interior.
4.
Correct the inflation pressure to 26 psi/
180 kPa. With the engine running:
Online Edition for Part no. 01 41 2 604 483 - © 02/10 BMW AG